Disposal hums but will not grind
We cut power, free the jam with an auger or drain snake, and test the motor. If the windings are burned, we replace the unit with a new one sized to your kitchen.
Licensed Kitchen Sink Pros for same-day disposal replacement and install
Garbage Disposal Installation in Melrose Park, Illinois
When your old disposal grinds its last lemon peel, you need garbage disposal installation in Melrose Park, Illinois handled by a licensed plumber, not a handyman. We remove the dead unit, check the p-trap and drain pipe, and install a correctly sized disposal with new seals and plumber's tape. Most jobs finish in two to four hours. We serve homeowners and restaurants across Melrose Park and the surrounding suburbs.
Fast online booking
Request service today
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now 7087265955 → No spam. No obligation. Just practical help.
Careful work. Honest options.
About this service
Garbage Disposal Installation in Melrose Park, Illinois
Garbage disposal installation in Melrose Park, Illinois is the removal of a failed or undersized disposal and the mounting of a new unit to your sink flange, including the electrical connection, drain pipe alignment, and leak testing. A disposal is a motorized grinding chamber that sits under the sink and shreds food scraps so they flow through the p-trap instead of clogging the drain. When the motor burns out, the housing rusts through, or the unit starts tripping the breaker, replacement is usually cheaper than repair.
Most Melrose Park homes we visit have one of two problems: a builder-grade 1/3-horsepower disposal that finally died after years of coffee grounds and eggshells, or a jammed unit the homeowner tried to free with a drain snake and a plunger. If you have standing water in the sink or a slow draining sink that backs up every time you run the disposal, the unit is likely past saving. We offer same day garbage disposal installation in Melrose Park IL Illinois for these situations, and we carry common sizes on the truck.
- ✓ Stop Drain Clogs
- ✓ Fix Leaks at the Flange
- ✓ Quieter Kitchen
- ✓ Code-Correct Electrical
What's included
What Our Installation Includes
Every garbage disposal installation service melrose park il Illinois call includes the essentials: removal of the old unit, a new flange and gasket, plumber's tape, and a leak test. We also check the p-trap and drain pipe while we are under the sink. Add-ons like new wiring, p-trap replacement, or drain cleaning are quoted upfront if needed.
✓
Old Unit Removal
We disconnect the old disposal, remove it from the mounting ring, and haul it away. The area gets wiped down before we start the new install. This is included in every job.
✓
New Flange and Gasket
A new sink flange and gasket come with the install. We do not reuse old, corroded parts. This prevents leaks at the sink opening and gives the new disposal a clean seal.
✓
P-Trap Inspection
We open the p-trap and check for grease clog, food particle clog, or soap scum buildup. If it is dirty, we clean it. If it is cracked, we replace it. A clean trap protects your new disposal.
✓
Electrical Connection
We connect the disposal to its circuit, check the amperage draw, and make sure the ground is secure. If the existing wiring is unsafe, we quote a new circuit before proceeding.
✓
Leak Test and Cleanup
We run hot water through the disposal, feed test scraps, and watch for leaks at the flange, discharge tube, and p-trap. The cabinet floor gets wiped down and the old unit leaves with us.
How it works
What to Expect During Installation
01
Phone Assessment
You call 708-726-5955 and describe the problem: no power, humming, leaking, or completely dead. We ask the brand and age if you know it, confirm whether the sink drains at all, and book a window. Most calls get a same-day slot. You get an upfront price range before we roll.
02
Shutoff and Removal
We kill the breaker, unplug or disconnect the disposal, and place a bucket under the p-trap. The old unit comes off the mounting ring, and we inspect the sink flange and drain pipe for corrosion. Removal takes 15 to 25 minutes on a standard sink.
03
Flange and Drain Prep
We scrape old plumber's tape and pipe sealant off the sink opening, install a new flange and gasket, and check the p-trap for grease clog or soap scum buildup. If the trap is packed, we clean it now so the new disposal does not inherit a clogged line.
04
New Unit Install
We mount the disposal, connect the discharge tube to the p-trap, and wire the unit to its circuit. A pipe wrench and auger stay on the truck in case the drain needs attention. This step runs 45 to 75 minutes depending on cabinet space and wiring.
05
Test and Cleanup
We run hot water, feed test scraps, and watch for leaks at the flange, discharge tube, and p-trap. The breaker gets one final check. We wipe down the cabinet floor and haul the old unit away. Total on-site time is usually two to four hours.
Tools & methods
Tools and Methods We Use
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
RIDGID pipe wrench
Used to loosen and tighten the mounting ring and drain pipe fittings under the sink. The right wrench prevents stripped threads and cracked flanges.
Milwaukee cordless drill
Drives mounting screws and, when needed, drills pilot holes for new flange hardware. Cordless means no extension cords across your kitchen floor.
DrainX drain snake
Clears food particle clog and grease clog from the p-trap and drain pipe before the new disposal goes in. A clean line is essential for proper drainage.
General Pipe Cleaners auger
Reaches deeper clogs in the drain pipe when a standard snake is not enough. Used during installation if we find standing water or a slow draining sink.
Spartan Tool hydro jetting machine
For commercial kitchens and heavy grease clog, this machine scours the drain pipe walls with high-pressure water. We use it before installing disposals in restaurants.
Drain camera
Inspects the drain pipe and main sewer line for breaks, roots, or heavy sludge. We run it when the sink drains slowly even after clearing the p-trap.
Bucket and gloves
Catches water and debris during removal. Gloves keep hands clean and safe from sharp disposal blades and dirty p-trap sludge.
Real results
Before and after.
From Leaking Disposal to Dry Cabinet
Before
A homeowner in Melrose Park had a 12-year-old disposal leaking from the bottom. The cabinet floor was wet and starting to rot. The sink drained slowly because the p-trap was full of sludge.
After
We removed the old unit, cleaned the p-trap, and installed a new 3/4-horsepower disposal with a new flange and gasket. The leak stopped, and the sink drained in seconds. Total time: three hours.
Restaurant Kitchen Back Online
Before
A restaurant on Broadway Avenue had a commercial disposal fail during dinner service. The drain pipe was clogged with grease, and the sink was full of standing water. They needed emergency service.
After
We arrived within two hours, cleared the grease clog with a hydro jetting machine, and installed a new heavy-duty disposal. The kitchen was back online before the next shift. Total time: four hours.
Slow Sink Fixed with New Disposal
Before
A homeowner in Winston Park had a slow draining sink for months. The disposal hummed but would not grind. A drain snake cleared some debris, but the problem returned within a week.
After
We found the disposal motor was burned out and the p-trap was packed with food particles. We installed a new 1/2-horsepower disposal, cleaned the p-trap, and ran a drain camera to confirm the drain pipe was clear. Total time: two and a half hours.
Problems we solve
Problems We Solve with New Disposal Installation
A dead or failing disposal causes more than a smelly sink. It leads to clogs, leaks, and higher water bills. Here are the most common problems we fix with new garbage disposal installation melrose park il Illinois.
Ask a pro →↗
Water leaks from the bottom of the disposal
We remove the leaking unit, inspect the sink flange and p-trap for damage, and install a new disposal with fresh gaskets and plumber's tape. The leak stops immediately.
Sink drains slowly after using disposal
We clear the drain pipe with a drain snake or hydro jetting machine, clean the p-trap, and install a new disposal. The slow draining sink becomes a memory.
Disposal trips the breaker every time it runs
We test the amperage draw, check the wiring, and replace the disposal if the motor is failing. If the circuit is the problem, we run a dedicated 20-amp line.
Most residential installs run $180 to $450 in 2026, including the unit, labor, and disposal of the old one. A basic 1/2-horsepower replacement sits at the low end. A 3/4-horsepower unit with new p-trap and drain pipe work pushes toward the top. Commercial kitchen disposals cost more because of size and wiring. We give you a firm range on the phone before we book the call.
Replacement means we pull the failed unit, inspect the sink flange and drain pipe, and mount a new disposal in its place. We reuse the existing electrical circuit if it is safe and code-compliant, and we replace the flange, gasket, and plumber's tape as part of the job. It is the same scope as a new install, minus running new wiring.
Plan on two to four hours from arrival to cleanup. Removal takes 15 to 25 minutes. Flange prep and p-trap check add another 20 to 30 minutes. Mounting and wiring the new unit runs 45 to 75 minutes. Testing and cleanup take 15 minutes. If we find a main sewer line clog or need to run a new circuit, the job can stretch to five hours.
A straight replacement of an existing disposal on the same circuit usually does not require a permit in Melrose Park. New installation where no disposal existed before, or any job that involves new electrical wiring, may need one. We handle the paperwork when a permit is required and schedule the inspection as part of the job.
More services
Related Services
Drain CleaningA new disposal pushes food particles into the drain pipe. If that pipe is coated with grease clog and soap scum buildup, we clean it first with a drain snake or hydro jetting machine so the disposal has a clear path.Explore →
Drain SnakingFor stubborn clogs past the p-trap, we run a drain snake or auger through the drain pipe. This is often done during disposal installation if we find standing water or a slow draining sink that points to a deeper blockage.Explore →
Hydro JettingRestaurant and commercial kitchens in Melrose Park often need hydro jetting before a new disposal goes in. The high-pressure water scours grease clog and food particle clog from the drain pipe walls, giving the new unit a clean line to push into.Explore →
Sink Drain RepairCorroded drain pipe or a cracked p-trap will leak no matter how good the new disposal is. We repair or replace the drain pipe and p-trap as part of the installation when we find damage during removal.Explore →
Garbage Disposal UncloggingIf your disposal hums but will not drain, it may be jammed rather than dead. We free the jam with an auger or drain snake and check the p-trap. If the motor is burned out, we move straight to replacement.Explore →
Garbage Disposal RepairNot every failing disposal needs replacement. If the unit is under five years old and the motor still runs, we can often repair the flange, reset the breaker, or clear a jam. We tell you honestly which option makes sense.Explore →
P-Trap Cleaning and ReplacementThe p-trap catches debris before it hits the drain pipe. During disposal installation, we open the trap, clean out sludge and food particles, and replace it if the threads or seals are worn. A clean trap protects your new unit.Explore → Ready when you are
Get Your Garbage Disposal Installation in Melrose Park, Illinois
Call 708-726-5955 for same-day service. We are licensed, insured, and we warranty our work. You get an upfront price before we start, and we haul the old unit away. Most installs finish in two to four hours.
Call Now 7087265955 →
Request an appointment
Call for kitchen sink unclogging
Call 708-726-5955 any time, day or night. We answer the phone, give you a time window, and send a licensed tech with a snake, auger, and jetting equipment. Most kitchen sink clogs clear the same day you call.